Induction clamp CI-110

Features

CI-110 clamp are used for wireless induction of tracing signal from utility location transmitter to the located utility. Generally used for utility location at complex city areas.

Inductive clamp CI-110, CI-110/50, CI-110/100 and CI-110/125 are used for:

• Contactless induction of signal into cable or conducting line. The signal should have specific frequency and limited power, generated by AG-105 or AG-120 location transmitter (AG-105 uses specific CI-105 clamp).
• External locating receiver sensor when it is necessary to locate the cable in a bunch.

Operation method

Cable location (including lines under voltage)

• Connect induction clamp to output socket of the transmitter.
• Set the type of generation (pulse or continuous) and select signal frequency.
• Brace the cable with clamp. Make sure, both half-rings touch each other.
• Start the generation on transmitter.
• Select transmitted frequency in location receiver settings menu and locate the utility.
• After finishing the location, stop the generation on transmitter.
• Remove the clamp from the cable.

Selection of the cable from a bunch

• Induce tracing signal of test frequency on selected cable.
• Select same frequency as on transmitter in locating receiver menu and locate the cable.
• Connect inductive clamp to locating receiver.
• Consequently, brace each cable one by one in a bunch. Maximum signal level on receiver screen will indicate the cable you are looking for.