Detection and locating, measuring equipment
Water leak detectors, cable and pipe locators

Accessories for our equipment allow to:

  • Detect cable faults with electromagnetic method
  • Detect deterioration of insulation on cables by direct and non-contact methods
  • Location cable damage
  • Provide better sensitivity sensor for acoustic water leak detection
  • Trace PVC pipeline from inside

Accessories

Insulation fault detection sensor DKI-117

Insulation fault detection sensor DKI-117

DKI sensor is used with cable locating receiver (AP-019 or AP027) for location of insulation damage in power cables, gas and heat pipes. Operation of this sensor is based on the principle of voltage difference detection. DKI sensor consists of two isolated from each other electrodes connected to the preamp in handle.

Fault location sensor DODK-117

Fault location sensor DODK-117

DODK is used for insulation damage control at gas\oil pipes and power cable lines. This sensor operates with the receiver (AP-019, AP-027) and exploits the principle of voltage difference.

 

Pipe transmitter set MAG-05.X.XX

Pipe transmitter set MAG-05.X.XX

Set of pipe transmitter MAG-05.X.XX is used for location and depth measurement of non-conducting pipelines and drain channels on the depth up to 5m. It is used with the receivers supporting 512Hz frequency and “Sonde” mode.

Portable acoustic sensor ADM-227 with magnetic connection feature

Portable acoustic sensor ADM-227 with magnetic connection feature

Portable acoustic sensor “ADM-227” is used for acoustic water leak detection. It is used with «AP-027» receiver.

Portable electromagnetic sensor MED-127

Portable electromagnetic sensor MED-127

Sensor «MED-127» is used with AP 19 and AP27 series of receivers by Technoac. It is used for the selection of the cable from a bunch, for location of internal wiring and cable fault location.

Sensor NR-117

Sensor NR-117

NR-117 sensor is used for precise location of a single cable in a bunch of other cables.

This sensor is used with cable location receiver.

Induction clamp CI-110

Induction clamp CI-110

CI-110 clamp is used for wireless induction of tracing signal from utility location transmitter to the located utility. Generally used for utility location at complex city areas.